This is the front transom from "inside" the boat. Again, the purpose of this round of work was to fillet the front and rear transoms. If you notice at the top center of this pic, the thickened epoxy dripped. Why??? Because we were too lazy to run to the store for good duct tape. we used package tape instead, it didn't hold, and the peanut butter oozed through. This will cost us a lot more work in the long run, when it's time to sand.
Subscribe to:
Post Comments (Atom)
2 comments:
...but will it float:O)
You have a riveting web log
and undoubtedly must have
atypical & quiescent potential
for your intended readership.
May I suggest that you do
everything in your power to
honor your Designer/Architect
as well as your audience.
Please remember to never
restrict anyone's opportunities
for ascertaining uninterrupted
existence for their quintessence.
Best wishes for continued ascendancy,
Dr. Howdy
'Thought & Humor'
That's an excellent recommendation. I'll follow up on it immediately.
Post a Comment